What a Repeater Does

A repeater receives a transmission on one frequency and immediately re-transmits it on another, usually from a much better location with a better antenna. Because it sits high and is wired to a proper antenna, radios that cannot hear each other directly can both reach the repeater.

Typical repeater families include Motorola's MOTOTRBO SLR5000 series, which supports digital (DMR) and analog operation.

📋 Licensing First

India's license-free 446 MHz exemption covers hand-held peer-to-peer radios only, with no base station or repeater. A repeater needs licensed spectrum and the relevant authorisation from DoT/WPC. Sort this out before buying equipment.

What You Need

  • Repeater unit with a power supply.
  • Duplexer, if you use a single antenna for both transmit and receive.
  • Antenna and feedline. Low-loss cable matters, because long thin cable wastes power.
  • Surge protection and grounding for the antenna mast.
  • Backup power (UPS or battery) so communication survives a power cut.
  • Compatible radios programmed for the repeater frequencies.

Step-by-Step Setup

  1. Define coverage. Mark every area that must be reachable, including basements, parking and far corners.
  2. Choose the site. The highest practical point with clear surroundings, usually a rooftop or tower, with power and secure access.
  3. Obtain authorisation and your frequency pair.
  4. Install the antenna as high as practical, away from metal obstructions, with proper grounding.
  5. Connect duplexer and feedline and check for a good match (low reflected power).
  6. Program the repeater and radios. For digital systems, set colour code and time slots consistently.
  7. Test. Walk or drive the whole coverage area with a radio, noting dead spots.
  8. Document and maintain. Record settings and schedule periodic inspections.

Troubleshooting

SymptomLikely CauseFix
Radios hear each other poorlyAntenna too low or obstructedRaise or relocate the antenna
Repeater keys up but no audioTone or colour code mismatchMatch radio and repeater settings
Weak coverage at far endCable loss or poor connectorUse lower-loss cable, check connectors
Interference or desensitisationDuplexer issue or nearby transmittersCheck duplexer, filtering and site
Dead after power cutNo backup powerAdd UPS or battery backup
⚠ Safety

Mast work needs trained climbers, correct grounding and lightning protection. Keep people clear of antennas while the transmitter is active.